MX-5111N MX-EB12 (MIRRORING KIT) 29 – 2
B. Mirroring unit attachment
1) Disconnect the connector of the standard HDD from the HDD
and the MFP control PWB.
2) Remove the mini-saddle and the protection sheet attached to
the mirroring unit (Packed items).
NOTE: Keep the removed mini-saddle and the protection sheet for
use again.
3) Fix the communication harness to the frame of the mirroring
unit with the banding band (Packed items) with reference to
the banding band which is fixing the communication harness.
Trim the edge of the banding band to leave about 1mm.
NOTE: Attach the banding band so that its head faces outward.
4) Fold the communication harness with reference to the banding
band which is fixing the communication harness.
5) Fix the communication harness with the banding band
(Packed items) with reference to the banding band which is fix-
ing the communication harness.
6) Put the bound communication harness under the SATA har-
ness.
7) Attach the protection sheet and the mini-saddle which were
removed in the above procedure to the mirroring unit.
NOTE: Arrange so that the communication harness comes out of
the opening of the protection sheet.
8) Attach the mirroring unit to the standard HDD, and connect the
connector.
Fix the mirroring unit with the screws (Packed items).
Pass the communication harness through the saddle and con-
nect to the MFP control PWB.
Banding band
(Fixing position reference)
Banding band
(Packed items)
Banding band
(Reflection reference)
To Next Page
Loading...
