MX-5111N MX-PNX6A/B/C/D (PUNCH MODULE) 16 – 2
C. Packed items check
2. Installation
NOTE: Before installation, be sure to turn both the operation and
main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.
NOTE: Before installing the punch unit, unpack the finisher.
A. Installation of punch unit
1) Attach the step screw A (Packed items) to the finisher.
2) Remove the fixing screw, and remove the connector cover on
rear side of the finisher.
3) Hang the punch unit on the step screws installed to the fin-
isher.
4) Tighten the step screws bundled to the punch unit, fix the
punch unit.
No. Name Quantity
1 P tight M4x12 1
2 Step screw A 2
3 Cap screw M3x6 3
4 Binding head M4x12 4
5 Front cover 1
6 Front cover mounting fixture 1
7 Connection fixture F (for punch) 1
8 Connection fixture R (for punch) 1
9 Guide mylar upper 1
10 Guide mylar lower 1
To Next Page
Loading...
