MX-5111N MX-FN11 (FINISHER) 14 – 5
2) Install the connection fixture F (Packed items) to the main unit
with the fixing screws (Packed items).
G. Attaching the cushion
1) Attach the cushion (S) (Packed items), the cushion (M)
(Packed items) and the cushion (L) (Packed items) to the posi-
tion indicated in the figure.
H. Check of the connected position of main unit
and finisher
1) Insert the rail of the finisher into the slit on the rail reception
sheet metal of the main unit, install the finisher.
2) Remove the screw, and remove the connector cover on rear
side of the finisher.
3) Check that the center of the screw hole of the finisher is in the
range of specification of an oval hole of the connection fixture
that exist on main body rear side.
* When not the range of specification, progress to the proce-
dure of "I. Adjustment".
If the adjustment is not required, remove the screws from
the screw hole directly and push the caster into it until the
installation fixing.
To Next Page
Loading...
