Sharp MX-B382 - Page 35

SHARP
TEST SIMULATION
35
24
Data Counter & Clear
7
Drum correction counter clear
9
Print & other counter clear
10
Fax counter clear [MX-B382]
15
Network scan counter clear [MX-B382]
25
Toner usage estimator counter clear
30
Administrator password initialisation
31
Service password initialisation
34
Initialise Sim 26-32 settings
25
DV Auto Adjustment & Monitor
1
Toner sensor monitor (Process drive)
2
Auto developer adjustment setting
26
Device Configuration
2
LCC size set-up
3
Auditor setup [MX-B382]
6
Destination set-up
10
Network scanner trial mode [MX-B382]
18
Toner save operation
30
CE mark control setup
32
System setting menu display setting
35
Trouble memory mode setting
38
Engine life over setting (Developer)
41
Pamphlet mode AMS operation [MX-
B382]
49
Copy mode setup (Postcard) [MX-B382]
50
Function setting
52
Blank paper count mode setting
53
Enable/Disable auto calibration [MX-
B382]
54
Enable/Disable auto calibration for printer
65
Finisher alarm mode set-up
69
Toner near end setting
73
Poster enlargement adjustment [MX-
B382]
74
OSA Trial Mode setting
78
Remote panel operation password setting
30
Sensor Operation & Test
1
Main unit sensor check
2
Tray sensor check (main)
40
Bypass Operation & Adjustment
2
Bypass tray width adjustment
7
Bypass tray width detection manual
setting
41
OSS Adjustment [MX-B382]
1
Document sensor operation check
2
Document sensor output setup
3
Document sensor output display
43
Fuser Setting & Adjustment
1
Fuser temperature setup (Paper)
4
Fuser temperature. setup for each mode
20
Fuser correction for low temp/humidity
21
Fuser correction for high temp/humidity
22
L/L correction for fuser temperature
setting
23
H/H correction for fuser temp. setting
24
Fuser temperature reset
44
Process Control Data
1
Process control mode setting
2
Process control Gain Adjustment
4
Process control initial density setup
6
Process control correction (force)
9
Process control data display
12
DM data, patch/base data display
14
Temp.& humidity output data
16
Toner control output data display
21
Half tone process control registration
22
Half tone process control patch result
24
Half tone correction data result display
25
Initial half tone correction data display
26
Half tone process control correct
execution
27
Half tone process control correction clear
28
Process control timing (On/Off) setting
29
Enable/disable half tone correction (job)
37
Image density (DVB) adjust setting
43
DV unit installation monitor
46
Image Density Adjustment [MX-B382]
2
B/W copy density adjustment [MX-B382]
4
Colour scanner density adjustment.
5
B/W scanner density adjustment.
8
Colour scanner balance adjustment.
9
SPF exposure adjustment.
16
Engine balance manual adjustment B/W.
19
B/W auto exposure mode setup.
21
Engine density balance adjustment
23
Engine maximum density adjustment.
24
Engine half tone auto adjustment.
32
Document background density adjustment