Sharp MX-B382 - Page 37

SHARP
TEST SIMULATION
37
60
Memory Operation & Test
1
SDRAM read/write test (ICU)
2
SDRAM data set
61
LSU Writing Adjustment/Test
1
LSU test (Polygon & BD signal check)
3
LSU power auto setup
4
LSU position adjustment (CMYK)
62
HDD Operation & Test
1
HDD format (FAT32)
2
HDD partial read/write check
3
HDD read/write check (all areas)
6
Smart (HDD) self diagnostics test (must be
FAT32 formatted)
7
Smart (HDD) self diagnostics error log
(FAT32 formatted)
8
HDD format (excluding system &
operation manual area)
10
Job completion list deletion (with job log)
11
Document filing data deletion
12
Enable/disable auto format for HDD
13
HDD format (manual area only)
63
CCD Operation & Adjust [MX-B382]
1
Shading correction data display
2
Shading correction execution (force)
3
CCD gamma & colour correction auto
adjustment
4
SIT chart patch density list display
5
CCD gamma & colour correction (reset)
64
Self Test Print
2
Engine colour balance patch print mode
4
Printer self print test
5
Printer self print test (PCL)
6
Printer self pint test (PS)
7
Adjustment pattern print (Sim46-21)
65
LCD Operation & Adjustment
1
LCD touch panel adjustment [MX-B382]
2
LCD touch panel adjustment result display
[MX-B382]
5
Operation panel key input test
66
Fax Control Settings [MX-B382]
1
Fax Soft SW setting
2
Country code default set (Fax)
66
Fax Control Settings [MX-B382]
3
Fax PWB controller memory check
4
Fax signal line check (Max level)
5
Fax signal line check (Soft SW setting)
6
Fax list print (confidential registration)
7
Fax memory printout (all data)
8
Fax voice message setup
9
Fax signal line check (Soft SW setting)
10
Fax all memory clear
11
Voice signal check (line/speaker 300bps)
12
Voice signal check (line/speaker 300bps)
13
Register dial number for Sim 66-14/15/16
14
Adjust/check the time dial pulse (10bps)
15
Adjust/check the time dial pulse (20bps)
16
Adjust/check the send level DTFM signal
17
DTFM signal to send to line (Max level)
18
DTFM signal to send to line (Soft Sw level)
19
Write Fax Pwb SRAM data to Flashcard
20
Write telephone book data onto HDD
21
Print various registration information
22
Set the sound volume of the handset
24
Fast memory data clear
25
Register fax number for modem dial in
26
Modem Dial-in telephone no. registration
29
Fax address book clear
30
Tel/LIU sensor status check
31
ON/OFF setting of output port (Tel/LIU)
32
Received data check (comparison)
33
Busy Tone/CNG/CED/FNET signal check
34
Display time required for sending test data
36
Check Send/Receive from modem.
39
Check Destination saved in Fax EEPROM
42
Rewrite PIC program installed on Fax box
43
Write program & adjustment values to PIC
installed on Fax
67
Printer Settings & Adjustments
17
Printer NVRAM clear
24
Printer half tone auto adjustment
25
Printer half tone colour adjustment
31
Printer calibration data clear
33
Printer screen gamma adjustment
34
Engine maximum adjustment mode for
printer
36
Adjust low density section
70
MFP PWB SRAM data clear