Sharp MX-B382 - Page 39

SHARP
TROUBLE CODES
39
F3
12
Lift up trouble Cassette 1 (Main unit)
F6
00
ICU-Fax communication trouble (ICU)
[MX-B382 only].
01
Fax EEPROM read/write error.
[MX-B382 only].
F6
04
Fax modem operation trouble.
[MX-B382 only].
21
LIU & Fax soft switch error (combination)
[MX-B382 only].
30
Access error to 1-chip on Fax board.
[MX-B382 only].
97
Fax Pwb compatibility trouble.
[MX-B382 only].
98
Improper combination of Fax &
Destination information. [MX-B382 only].
H2
00
Non contact thermistor open
(TH_UM_AD1).
01
Lower thermistor open (TH_LM).
02
Sub thermistor open (TH_US).
03
Compensation Thermistor open trouble
(TH_UM_AD1)
04
Thermistor open (TH_EX1)
05
Thermistor open (TH_EX2)
H3
00
Compensation Thermistor open trouble
(TH_UM_AD1)
01
Fuser high temperature (TH_LM).
02
Fuser high temperature (TH_US).
04
Fuser high temperature (TH_EX1).
05
Fuser high temperature (TH_EX2).
H4
00
Fuser low temperature (TH_UM_AD2)
01
Fuser low temperature (TH_LM)
02
Fuser low temperature (TH_US)
04
Fuser low temperature (TH_EX)
30
Thermistor input trouble (TH_UM)
H5
01
5 continuous (POD1 not reach) jams
H7
10
Fuser low temperature (TH_UM_AD2)
11
Fuser low temperature (TH_LM)
12
Sub thermistor fusing section low
temperature (TH_US)
14
Low temperature trouble (TH_EX) in
reset operation after Job stop due to a
fall in fuser temperature
H8
00
Fuser unit initial detection trouble
L1
00
Mirror feed trouble.
L3
01
Mirror return trouble.
L4
02
Paper feed motor trouble
03
Fuser motor lock trouble
04
DV motor trouble
06
Transfer unit lift trouble
12
Secondary transfer separation trouble
16
Fusing pressure release trouble.
29
HDD Fan trouble
30
MFP fan motor trouble
31
Paper exit cooling fan trouble
32
Power source cooling fan trouble
34
LSU fan trouble
35
Fusing cooling fan trouble
50
Process fan trouble
51
Process fan 2 trouble
L6
10
Polygon motor trouble (LSU)
L8
01
No Full wave signal
02
Full wave signal width trouble
20
MFP PWB communication trouble