Sharp MX-C507P - Page 212

5028
Error on every page service check
Diagnostics and troubleshooting
178
Action
Yes
No
Step 1
Check if the media loaded has an RFID tag (A) attached or
embedded.
• Sample RFID media
Note: This image shows a typical RFID tag. The actual tag
varies in size, shape, and appearance, as well as position and
orientation on the page.
Note: This error indicates that the printer attempted to program
an RFID tag and failed to do so. To disable the printer from
programming the RFID tag, navigate to Settings > RFID , and
then set Stop on Error to YES. You can also modify by the Retry
Count setting. Navigate to Settings > RFID > Retry Count , and
then assign a value except 0.
Is the tray loaded with an RFID media?
Go to step 3.
Go to step 2.
Step 2
Load the tray with an RFID media.
Does the problem remain?
Go to step 3.
The problem is
solved.
Step 3
Check if the RFID media is loaded in Tray or Tray 4.
Note: Because the RFID Option is installed in the Tray 2 position,
RFID media loaded in Tray 1 cannot pass through the Option and
cannot be programmed. Thus, load RFID media only into Tray 3
or Tray 4.
Is the RFID media loaded in Tray 3 or Tray 4?
Go to step 5.
Go to step 4.