Sharp MX-C507P - Page 299

5028
Auto alignment service check
Pre ‑ check procedure
1
2
Open and close the toner door a few times to clean the sensor (TPS) lenses.
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments > Color alignment adjust
On the AA adjustment row, touch Start .
Note: This triggers the auto align routine which performs the color alignment error corrections (0.42
mm, 0.84 mm, and 3 mm range).
Note: If the AA adjustment is successful, an AA adjustment passed message appears on the
screen. If an AA adjustment passed message does not appear, skip the next pre-check step,
and then go directly to step 3 in the service check.
Enter the Diagnostics menu, and then navigate to:
Printer setup > EP setup > Toner patch sensor adjust > Full calibration
Note: This triggers the auto align routine (0.42 mm range only).
3
4
Diagnostics and troubleshooting
265
Action
Yes
No
Step 1
a From the home screen, touch Settings > Reports > Print
Quality Pages .
b On the CalSet section of the test page, check the color
alignment stat value.
Is the value 0?
Go to step 2.
The problem is
solved.