Sharp MX-C507P - Page 305

5028
Behavioral issues (without error codes) of printers with RFID Option
The following table details the actual behavior of the printer to every possible RFID setting combinations. To
access the RFID menu:
1 From the home screen, touch Settings .
2 Select RFID , and then configure the settings.
Note: If the printer continues to behave inconsistently with the menu settings as indicated below, this may
indicate a hardware problem. Contact the next level of support.
Notes:
• N is any number greater than 0 as specified in the Retry Count setting.
• We do not recommend using the last two combination of settings. These settings allow unprogrammed or
failed tags into the output with no indication of failure.
Diagnostics and troubleshooting
271
Setting combination
Actual behavior
Stop on Error
Mark on Error
Retry Count
Yes
Yes
0
(Default) All failed pages will be marked and a 44.01 error
will be posted.
Yes
No
0
44.01 error will be posted on all failed pages.
No
Yes
0
Failed pages will be marked, but no 44.01 error will be
posted.
Yes
No
Any number greater
than 0
Failed page will be reprinted up to N times before 44.01
error is posted. Failed pages will not be marked.
Yes
Yes
Any number greater
than 0
Failed pages will be reprinted up to N times. Each failed
page will be marked. After N retries, 44.01 error will be
posted.
No
Yes
Any number greater
than 0
Failed pages will be reprinted up to N times. Each failed
page will be marked. After N retries, the printer will move
to the next page in the job. 44.01 error will not be posted.
No
No
0
There will be no indication of failed pages.