MX-M753N MX-CF10 4 – 6
5) Only when the MX-FN14 is installed, attach the grip blinding
sheet to the grip section on the front cover and fix the front
cover with a screw G (1 pc.).
6) Check that the finisher lock lever is engaged on the inserter
groove securely.
(1) When the inserter cannot be installed to the
finisher
When the finisher and the inserter differ in the height, perform the
following height adjustment, and attach the inserter.
1) Set all the finisher height adjustment screws (4 positions) to
the center positions.
2) Attach the inserter to the finisher. (Refer to the procedure F. in
this section.)
G. Fix the extension guide of the tray
1) Pull out the extension guide of the inserter paper feed tray until
it stops.
2) Tighten the fixing screws F (2 pcs.) on the back side of the
paper feed tray.
H. Install the connection plate (Use the packaged
parts of the finisher.)
1) Install the connection plate to the inserter with the fixing
screws G (2 pieces.).
NOTE: The plate and the connection plate are common to the fin-
isher. Please reuse rail and connector plate for inserter.
I. Connect the connector
1) Connect the finisher relay harness connector to the inserter
connector, and tighten the connector screw to fix it.
2) Fix the finisher relay harness to the rear side of the inserter
with two clamps.
To Next Page
Loading...
