1-56
BEFORE USING THE MACHINE
FINISHER (3 TRAYS)
The finisher (3 trays) is equipped with the offset function, which offsets each set of output from the previous set, and the
staple sort function, which staples each set of output.
A punch module can also be installed to punch holes in output.
PART NAMES
(1) Stapler compiler
This temporarily stacks paper to be stapled.
(2) Middle tray
Open this cover to remove paper jams in the stapler
compiler.
(3) Output trays (upper tray, middle tray*, lower tray)
Stapled and offset output is delivered to these trays.
The trays are slidable. For large-size output (11" x 17",
8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 13-1/2",
8-1/2" x 13-2/5", A3, B4 and 8K sizes), extend the tray.
(4) Right front cover
Open this cover to remove a paper misfeed.
(5) Left front cover
Open this cover to replace the staple cartridge or remove
a staple jam.
* Stapled and offset copies cannot be delivered to the middle
tray.
SUPPLIES
The finisher (3 trays) require the following staple cartridge:
Staple cartridge (approx. 5000 staples x 3 cartridges)
MX-SC10
(1)
(3)
(2)
(5)
(4)
• Do not place heavy objects on the finisher (3 trays) or press down on the finisher (3 trays).
• Use caution when you turn on the power and when printing is taking place, as the output tray may move up and down.
• A finisher (3 trays) cannot be installed simultaneously with a saddle stitch finisher or a finisher.
To Next Page
Loading...
Need help?
General
