MX-M753N AR-PN4 6 – 3
E. Connector connection
1) Connect the punch joint harness connectors (2 pcs.) of the
punch unit to the connectors (2 positions) of the finisher PWB.
F. Punch cover assembly
1) Attach the rear cabinet B to the original position, and fit it with
the fixing screws (2 pcs.).
2) Attach the punch cover and fix it with six fixing screws.
Close the front door of the finisher.
G. Position label attachment
1) Attach the punch position label bundled with the finisher to the
position shown in the figure.
H. Finisher connector connection
1) Remove the connector cover fixing screw for connection of the
finisher joint harness connector, and remove the connector
cover.
2) Connect the finisher joint harness connector to the main unit
connector, and tighten the screw on the connector to fix.
To Next Page
Loading...
