Why doesn't transmission begin at the specified time on my Sharp All in One Printer?
If another transmission is in progress when the specified time arrives, the timer operation will begin after that transmission is finished.
What to do if a destination is pre-selected on my Sharp All in One Printer?
If you wish to send to a destination other than the default destination, touch the [Cancel] key. If you are the administrator and wish to change or disable the default destination, change the settings as appropriate in "Default Address Setting".
What to do if transmission does not take place on my Sharp MX-M850 All in One Printer?
First, ensure the destination information is correct and the destination is properly selected. For e-mail delivery issues, check for "Undelivered Message" errors sent to the administrator's e-mail, as it may help identify the problem. Also, if you are trying to scan a long original, it cannot be scanned from the document glass; use the automatic document feeder instead. If a folded original is placed in the automatic document feeder, unfold it and rescan, following the display instructions. If the original size is not detected correctly, try placing the original again or manually specify the original size.
Why does my Sharp All in One Printer save JPEG as TIFF?
If the color mode is set to [Mono2], change the color mode to [Full Color] and then press the [START] key.
Why does auto selection of the color mode not take place correctly on my Sharp MX-M850 All in One Printer?
When the color mode is set to "Auto", the machine detects whether the original is black and white or color when the [START] key is pressed; however, automatic detection may not give the correct result. In this event, specify the color mode manually.
What to do if I cannot write to USB memory when using USB Memory Scan on my Sharp MX-M850 All in One Printer?
Ensure that the USB memory device is connected securely to your Sharp All in One Printer.
Why is the scanned image blank on my Sharp MX-M850 All in One Printer?
Check whether the original is placed face up or face down correctly. When using the document glass, the original must be placed face down. When using the automatic document feeder, the original must be placed face up.
Why is the transmitted fax reduced by the receiving fax machine from my Sharp MX-M850 All in One Printer?
This issue might occur if image rotation has not been enabled. Enable "Rotation Sending Settings" before transmission.
How to fix poor quality of scanned image on Sharp MX-M850?
If the original is printed matter such as a book or magazine, vertical patterns (moiré) may occur. Touch the [Exposure] key in the base screen to open the exposure setting screen; the [Moiré Reduction] checkbox appears in this screen. Also, if you are scanning a color or grayscale original, ensure that the color mode is not set to "Mono2". Setting the color mode to "Mono2" replaces the colors in the original with either black or white, which is suitable for text-only originals; however, originals with illustrations should be scanned with the color mode set to [Grayscale], [Full Color], or [Auto] - [Grayscale].
Why is the scanned image clipped on my Sharp MX-M850?
The original scan size setting might be smaller than the actual original size. Set the scan size to the actual original size. If you have intentionally set a smaller size than the actual original size, note carefully the placement position of the selected scan size when placing the original.
General| Print Resolution | 1200 x 1200 dpi |
|---|---|
| Connectivity | Ethernet, USB |
| Copy Resolution | 600 x 600 dpi |
| Functions | Copier, Printer, Scanner |
| Print Speed | 85 ppm |
| Scanner Type | Color |
| Display | 10.1-inch color touch-screen |
| Hard Drive | 320 GB |
| Scan Resolution | 600 dpi |
| Copy Speed | 85 ppm (black) |
| Network Connectivity | Ethernet (10Base-T/100Base-TX/1000Base-T) |
| USB Connectivity | USB 2.0 |
| Operating Systems Supported | Windows |
To Next Page
