Sharp MX-M904

Test Simulation
48
SHARP Document Solution Centre
53
Document Feeder Adjustment
6 DSPF document tray size adjustment
7 DSPF document tray size adjust value set.
8 DSPF scanning position adjustment
9 DSPF dirt detection setting
10 DSPF dirt detection execution
12 DSPF double feed sensor operation check
55
MFP Data Setting
1 Engine soft switch setting
2 Scanner soft switch setting
3 Controller soft switch setting:-
SW1-5 Auto clear function before copy
job execution:-
0 =Disabled, 1 = Enabled
SW3-6 Process mixed original size
printing for duplex mode:-
0 =Disabled, 1 = Enabled
SW3-7 HP Compatibility Mode:-
0 =Disabled, 1 = Enabled
SW4-5 Paper type simplification
selection:-
0 =Disabled, 1 = Enabled
SW4-7 Paper feed size entry:-
0 =Disabled, 1 = Enabled
SW6-1 Ethernet Speed Auto
negotiation:-
0 = Enabled, 1 = Disabled
SW6-2 Ethernet Link Speed:-
0 = 100Base TX, 1 = 10Base T
SW6-3 Ethernet Duplex Mode:-
0 = Full, 1 = Half
SW6-4 Ethernet 100/1000 Link Speed:-
0 = 100Base TX, 1 = 1000Base T
SW6-8 USB Card Reader detection
control
0 =Disabled, 1 = Enabled
SW9-5 Maintenance notification setting
by Printer MIB:-
0 = Enabled, 1 = Disabled
SW22-5 Display toner remaining (MFP
Status):-
0= Disabled, 1 = Enabled/Display
SW24-7 Continuous print mode for OSA
(job queuing for MXAMX3):-
0 = Job Queue Disabled
1 = Job Queue Enabled
55
MFP Data Setting
3 Controller soft switch setting:-
SW25-7 Custom Envelope size (Printer).
0 = Disabled, 1 = Enabled
SW26-1 Notification sound of finished
Copy job.
0 = Disabled, 1 = Enabled
SW26-2 Notification sound for Stop copy
when no original is present
0 = Disabled,
1 = Enabled
SW27-7 Set printable area to same as
previous model
0 = CR3 series (Default)
1 = CR2 series
SW27-8 Retain Scan to Desktop
destination for a certain period
after a scan operation.
0 = Disabled (Default)
1 = Enabled
SW28-3 Single Email alert notification for
customer.
0 = Disabled (Default)
1 = Enabled
SW28-4 Envelop mode – automatically
change to size tab screen.
0 = Disabled (Default)
1 = Enabled
SW28-6 Disable Multi Shot & Pamphlet
function when reprinting
retention data.
0 = Disabled (Default)
1 = Enabled
SW28-7 The [X] keys indicating
determination of setting can be
changed to [OK] keys
0 = Disabled
1 = Enabled (Default)
10
Special Stamp setting (Taiwan only)
56
MFP Data Import & Export
1 Transfer data execute (MFP/SD Card/SRAM
& EEPROM)
2 Export/Import EEPROM/SD/HDD data
3
Document filing data backup to USB
4 Job log data backup to USB
5 Export Adjustment & Settings data to USB