3.2
Connection to Display Unit
Be
sure to turn
off
both
the computer and display
unit
before connecting them.
3.2.1 Connecting a TV set to the
~¥~Z-700
Disconnect the antenna feeder from the UHF antenna terminals
of
the TV set. Plug
the
connection
cable provided into the
RF
signal
output
jack
on
the
rear panel
of
the
computer and connect
the
pin plugs
on
the
cable's
other
end to the 75-ohm UHF antenna terminals
on
the
TV set.
Back view
of
MZ-700
Back view
of
Home
TV
Set the channel selection switch
to
the 36 ± 3 eh position, depending
on
which
is
not
used in
your
area.
Note the following when using an ordinary TV
set
as a display unit.
• Adjust controls (fine tuning, color control,
etc
.)
of
the TV set
to
optimum
conditions before con-
necting
·
it
to
the computer.
• Note
that
color and quality
of
displayed images will be poorer with a TV set than when a special
color
monitor
unit
is used.
Further,
note
that
images may be painted with the wrong colors
or
may
not
be colored
if
the TV set is
not
properly adjusted.
• Part
of
the screen may be omitted
if
vertical and horizontal scanning frequencies
of
the
TV
set
do
not
match
those
of
the computer. This is
not
a problem with the computer; contact
your
TV dealer.
• Part
of
the screen
may
not
be visible
if
the image is
not
centered.
• Be sure to remove the antenna feeder from the TV set before connecting
it
to
the computer; other-
wise,
the
signal from the
computer
will radiate from the TV antenna, possibly interfering with
other
TV sets.
• Be sure to connect the
computer
to the 75-ohm antenna terminals
of
the
TV
set.
If
the cable pro-
vided
cannot
be used, be sure
to
use a 75-ohm coaxial cable.
• Characters may be hard to read with certain combinations
of
foreground and background colors.
In such cases, switch the B/W-color switch to the B/W position to obtain higher contrast. The best
combination
of
the foreground and background colors
is
white for the foreground and black or
blue for the background.
• No audio signal
is
included in the RF signal fed
to
the TV set, so sound cannot be
output
from the
speaker
of
the TV set.
106
----
--------
----
----------
----
--------------------------------
--
----
-
To Next Page
Loading...
