3.3
Data Recorder
• Data recorder built into
the
MZ-731
and
MZ-721
The built-in data recorder can be operated in the same
manner
as
an ordinary cassette tape recorder.
R
EC
ORD
PLAY
REWIND
FFWD
STOP/ EJECT I
• MZ-1T01
Press this key
to
record programs and data.
Press this key to load programs and data.
Press this key to rewind
the
tape.
Press this key
to
fast-forward the tape.
Press this key to stop the tape,
to
release
other
keys when the tape stops after
loading
or
recording programs
or
data,
or
to eject the tape.
The
MZ-1
TO
I data recorder unit can be installed in the MZ-711 (MZ-
71
0). Installation procedures are
as
follows.
I.
Turn
off
the
computer's power switch and unplug
the
power cable from
the
AC outlet.
2. Remove the two screws located on the left side
of
the rear panel
to
remove the
data
recorder com-
partment
cover.
3. Remove the
joint
connector cover.
4. Plug the connector
of
the
MZ-1
TO
I
onto
the 9-pin connector located at the left rear
of
the recorder
compartment
of
the MZ-711.
5. Position the data recorder in the recorder
compartment
and fasten it in place with the two screws.
When doing this, be careful to
avoid catching the
connector
cable between the
data
recorder and
the
computer
, (otherwise, the screws
cannot
be tightened).
108--
--
----------------
--
----
--
------------
----
------
----
--------------
-
To Next Page
Loading...
