• Loading roll paper
1.
Remove the printer cover.
2.
Cut
the end
of
roll paper straight across and insert the
end
into
the paper inlet. (Be careful
to
avoid
folding or wrinkling the
end
of
the paper when doing this.)
3.
Turn
on MZ-731 's power switch and press the w (paper feed) key
to
feed paper until the
top
of
paper is 3 to 5 cm above the outlet.
4. Insert
the
paper shaft
into
the roll and
mount
it
to
the paper holders.
5.
Set the printer cover so
that
the end
of
paper comes
out
through the paper cutter.
• To remove the roll from the
printer
for replacement,
cut
straight across the paper
at
the paper
inlet and press the paper feed key.
• Roll
paper
for the MZ-700 series computers
is
available at any Sharp dealer. Do
not
use paper
other
than that specified.
The length
of
the
paper
is
23 to 25 meters, and the maximum roll diameter which can be loaded
is
50
mm. Paper will
not
feed properly
if
a roll with a greater diameter
is
used, resulting in
poor
print
quality.
Procedures
for
loading roll paper
(C)
Replace
the
printer
cover.
(A)
Insert paper into
the
paper inlet.
(B)
Press
the
paper feed key
to
feed paper.
-----------------------------------------------------------------------
111
To Next Page
Loading...
