• MZ-lPOl
Installation
of
the
MZ-1
PO
1 col
or
plotter
printer (for models
other
than
the
MZ-731)
1.
Turn
off
the computer's power switch and unplug the power cable.
2.
Remove the two screws located at the center
of
the rear panel to remove the
printer
compartment
cover.
3. Confirm
that
the
printer
switch on
the
printed circuit board is set
to
the INT position.
4.
Plug the
printer
connector
into
the matching
connector
on the printed circuit board,
then
position
the
printer
in the
printer
compartment
and fasten
it
in place with the two screws. When doing this,
be careful
to
avoid catching the
connector
cable between the data recorder and
the
computer (other-
wise, the screws
cannot
be tightened).
Power connector
Connection
of
color plotter-printer
to
the MZ-700
• Connecting an external printer (MZ-80PS(K))
The MZ-80P5(K)
printer
for the MZ-80K series computers can be connected to the MZ-700's external'
printer
connector
(see page
104)
without
any special interface card. Use an optional connection cable
for making the connection.
When using an external printer, the printer switch on the printed circuit board
must
be set to the
external
printer
position. Therefore, the color plotter-printer and the external
printer
cannot be used
simultaneously.
Note
that
if
a program including color plotter-printer control statements
is
run
with an external printer,
meaningless characters (control codes for the plotter-printer) will be printed.
----------
----------
----
------------------
--
------------
----
-----------
113
To Next Page
Loading...
