Sharp MZ-800 User Manual

1.2 Handling
1) This computer uses many precision parts. Do not use or store it in extremely hot or cold condi-
tions, or under conditions where the temperature changes rapidly.
2) Do not use or store the computer in damp or dusty places, and avoid exposing it to corrosive chem-
icals or gases.
3) Do not block the ventilation holes or place large objects nearby that will disrupt ventilation.
4) Do not subject the computer to shock or vibration.
5) Do not expose the computer to direct sunlight.
6) Do not allow water or other liquid to enter the cabinet. Using the computer when it is wet is very
dangerous, and will damage the computer’s electronics.
7) Do not disassemble the cabinet unless you are installing options as instructed by documents from
SHARP.
8) Radios and TV sets may pick up interference from RF (radio frequency) noise generated by the
computer. Keep such equipment (other than that you may be using as the computer’s display unit)
well away from the computer.
9) When peripheral devices are connected, the display image may jitter. If this problem occurs, change
the layout of your system’s equipment.
10) Do not place any object other than the optional plotter/printer (MZ-1P16) on the cabinet.
11) After turning off the power switch, unplug the power cable by grasping the plug molding, not
the cable.
12) Make sure that you turn off the power switch when you not using the computer. After turning
off the power switch, wait at least 10 seconds before turning it on again, otherwise the system
may not operate properly.
13) Use a dry soft cloth to clean the unit. Do not use a wet cloth or volatile fluids such as alcohol
or benzene. Discolouration or deformation of the cabinet may result if this precaution is ignored.
14) If you notice any abnormal condition such as an extremely high temperature, an abnormal odour,
or smoke, stop what you are doing and quickly turn off the power then unplug the power cable.
MZ-811 and MZ-821
One of the models described in this manual may not be available in some countries.
This manual explains two personal computer models: the MZ-811 and the MZ-821. Differences
between these two computers are as follows.
Model name | MZ-811 MZ-821
|
Data recorder | Optional Standard
|
Not connectable
Ordinary cassette recorder | Connectable
When the optional MZ-1T04 data recorder is installed on the MZ-811, it becomes equivalent
to the MZ-821. Procedures for installing the data recorder are described in the MZ-1T04 in-
struction manual.
The explanations in this manual are based on the MZ-821.
However, the explanations on pages 7-3 and 7-18 apply only to the MZ-811.

Sharp MZ-800 Specifications

General

Brand	Sharp
Model	MZ-800
Category	Desktop
Language	English