Sharp MZ-800 User Manual

1.4 Setup
To operate your MZ-800 computer, you must first set up the system. To do this, you will need to con-
nect a display unit to see what the computer is doing. SHARP supplies several types of display units
for the MZ-800 computer, or you can use an ordinary home TV set providing it can receive the VHF
band. The minimum configuration your computer can operate with is shown below:
The following explanation shows the setup procedure for a typical system.
(1) Using a TV set
To use a TV set as the display unit, use the monitor cable provided with your MZ-800.
1) Disconnect all antenna cables from the TV set. (If they are left connected, RF interference generat-
ed by the computer will be radiated from your TV antenna, which may interfere with neighboring
TV sets.)
2) Insert the monitor cable pin plug into the RF pin socket on the rear of the MZ-800. Connect the
other end of the cable to the 75-ohm UHF antenna terminal on your TV set.

Sharp MZ-800 Specifications

General

Brand	Sharp
Model	MZ-800
Category	Desktop
Language	English