Sharp MZ-800 - Page 116

RESET
See also
RESET [<colour specification >] <X-coordinate >, < Y-coordinate>
<colour specification> = <palette code>,<superimpose mode>
The RESET statement changes the colour of a dot on the screen at the point speci-
fied by <X-coordinate> and <Y-coordinate> according to the rule shown be-
low. <X-coordinate> and < Y-coordinate> are numerical expressions (i.e., numeric
constants, variables, or expressions). They can have values in the following ranges:
~ 16384 < <X-coordinate> <16383
— 16384 = <Y-coordinate> = 16383
Their range of values is the same as that for the SET statement. <palette code>
specifies the palette code for the colour of the dot to be reset. <mode> must be
either 0 or 1. See Appendix A for more information.
SET
6-59