Sharp MZ-800 - Page 173

M Command (Memory set)
Format M<starting address >
Explanation This command modifies the contents of the main memory. When the <starting
address> is omitted, modification is made from the address indicated by the cur-
rent pointer. To return to the monitor prompt, press | BREAK | while holding down the
(SHIFT) key.
When the M command is entered, the cursor positions itself at the data for the speci-
fied address. The address pointer is incremented by the number of data bytes specified.
Data may be either a 2-digiht hexadecimal or a character preceded by a semicolon.
F Command (Find)
Format F<starting address> <end address> <data><data> ...
This command searches for one or more bytes of data at the specified addresses,
and if found, displays the addresses and data with the format shown for the D com-
mand. To return to the monitor prompt, press while holding down the
key.
G Command (Gosub)
Format G<call address >
Explanation This command calls the specified address. The stack pointer resides at address SFEFF.
T Command (Transfer)
Format T<starting address> <end address> < destination address >
Explanation This command transfers data from the specified source address to the specified des-
tination address.
8-10