Sharp MZ-800 - Appendix D Console Control Codes

Appendix D Console Control Codes
If the MZ-800's character set, some of the codes are used to control the operation of the computer
as shown below. These control codes can be input to the computer through the keyboard or by using
the PRINT statement (indicated with an asterisk (*) in the code column).
Control code table
Code (Dec.) Key operation Function
5 [CTRL | + (E] Causes the character keys to input lowercase letters.
6 (Cerri ] + fF] Causes the character keys to input uppercase letters.
13 (*) [CTRL | + [M] Causes a carriage return.
16 (*) cri | + [Pp] Deletes the character at the position to the left of the
cursor position.
17 (*) CTRL | + (el Moves the cursor down one line. O 5
18 (*) CTRL | + Ik] Moves the cursor up one line. | t
19 (*) cTrt |] + [Ss] Moves the cursor right one character position.
20 (*) CTRL | + ca Moves the cursor left one character position. f)
21 (*) Cerrec) + (v] Moves the cursor to the home position.
22 (*) cTre | + [v] Clears the screen. [CLR |
23 (*) CTRL | + [w] Places the keyboard in the graphics mode.
24 (*) CTRL | + LX. Inserts a space at the cursor position.
25 (*) + Ly] Places the keyboard in the normal mode.
A-12