Sharp MZ-800 User Manual

The following message is then displayed.
| IPL is loading MZ-1Z016
Wait for several minutes, then the following display will appear on the screen. The tape stops auto-
matically, Press the STOP] button.
BASIC interpreter 12-016 VX.XX
Copyright (C) 1984 by SHARP CORP.
XXXXxX bytes free
Ready
.
L Cursor (blinking)
This display indicates that the BASIC interpreter has been loaded into memory and the MZ-800 is
ready to accept BASIC commands. This display is called the ‘‘initial’’ frame.
2.2 Power-off
When you switch the MZ-800 off, all programs and data stored in memory will be lost. Therefore,
execute a SAVE operation prior to powering the computer off. (Chapter 3 describes how to save data
onto the cassette tape.) To power off the MZ-800, finish any BASIC operations you may have started,
then check the screen to make sure ‘‘Ready”’ is displayed and the cursor is blinking. Switch OFF the
power switch.
Turn off the equipment in the following order.
1) Peripheral devices (such as the printer)
2) The expansion unit (MZ-1U06)
3) The MZ-800 computer
Note:
Do not power off the MZ-800 while the data recorder is operating (turning).
2-3

Sharp MZ-800 Specifications

General

Brand	Sharp
Model	MZ-800
Category	Desktop
Language	English