Sharp MZ-800 - Appendix K Error Messages Generated by the Monitor

Appendix K Error Messages Generated by the Monitor
[Cassette]
CMT: Loading error
An error occurred during data loading.
CHECK SUM ER.
An error was detected in the check sum for the loaded file.
Make ready CMT:
An attempt was made to access data before the | PLAY | button was pressed, or when no cassette
was inserted in the data recorder.
[MZ disk]
QD: Loading error
An error occurred during data loading.
QD: File mode error
The type of the starting file on the disk set in the drive-at the power-on sequence was not OBJ.
QD: File not found é
The specified OBJ file was not found.
QD: Hard err
A hardware error occurred.
Already exist err
A filename which is the same as that specified for the S command had been already cataloged
—- on the disk.
QD: Write protect
An attempt was made to access a write-protected disk.
QD: Not ready
An attempt was made to access data for the disk when the disk holder was opened or when no
disk was inserted in the drive.
QD: No file space err
Insufficient free space was left when a file was saved by the S command.
QD: Unformat err
The disk to be accessed was unformatted.
QD: Bad disk err
The disk to be accessed was defective.
Make ready QD
An attempt was made to access data when the disk holder was opened or when no disk was set
in the drive.
[Floppy Disk]
FD: Loading error
An error occurred during data loading.
FD: Not master
The disk set in drive-1 was not master disk.
Make ready FD:
An attempt was made to access data when the lever was not locked or when no disk was set
in the drive.