Sharp MZ-800 - Page 215

Error No. Message Displayed
Description
19 Instruction error A direct command was included in the program or an indirect
statement was used in the direct mode.
20 Can't RESUME error A RESUME statement cannot be used.
RESUME error
An attempt was made to execute a RESUME statement even
though no error occurred.
22 PAL error Palette block number is out of range.
24 READ error TA READ statement was encountered without a corresponding
DATA statement.
29 Framing error Framing error
30 Overrun error Overrun error
31 Parity error Parity error
40 File not found error An attempt was made to access a non-existent file.
42 Already exist error An attempt was made to save a file under a filename which al-
ready existed.
43 Already open error An attempt was made to open a file already opened.
44 Not open error An attempt was made to access, CLOSE, or KILL a file without
opening it.
Write protect error
An attempt was made to write data to a write-protected file.
51 Too many files error
An attempt was made to store more than 32 files in the RAM file
board.
No file space error
Free space for storing files is insufficient.
58 Dev, name error
An invalid device name was specified.
Can't execute error
An attempt was made to execute a statement for an invalid
device.
60 Illegal filename error An illegal filename was specified.
61 Illegal filemode error A file was accessed in an illegal mode.
— 63 Out of file error An end of file was encountered during a read operation of the
cassette.
64 Logical number error An error was detected in the logical number.
LPT: not ready error
The printer is not connected or not on-line, or a malfunction has
occurred in the printer mechanism.
Dev. mode error
An error was detected in the device mode.
| Unprintable error
An error occurred which does not have a message.
| Check sum error
An error was detected in check sum data.
A-28