Sharp MZ-800 - Page 64

CONT
CONT
Abbreviated Format
See also
Cc,
The CONT command is used to
interrupted by pressing |SHIFT
resume execution of a program which has been
+ [BREAK] or by a STOP statement in the
program, When the message ‘‘Ready’’ is followed by a period (.), the CONT com-
mand can be used. Examples of situations in which the CONT command can and
cannot be used are shown in the
Program continuation possible
table below.
© Program execution “rapes d "a
pressing (SHIFT ] + [BREAK ] .
© Program execution stopped by a
STOP command.
Program continuation not possible * Before a RUN command has been
executed.
« “‘Ready”’ is displayed due to an
error occurring during program
execution.
¢ When cassette operation has been
interrupted by pressing | SHIFT | +
(BREAK }.
* When program execution has stopped
during execution of a MUSIC
statement.
¢ After program execution has stopped
and “Ready” is displayed after
execution of the END statement.
STOP
6-7