2
WARNING
Do not apply vibrations or shocks to the product.
Do not install the product to unstable locations or
locations subject to vibrations.
Always ask a technician to perform the installation.
Do not connect the cables with wet hands.
Otherwise, it may cause an injury or an electrical
shock.
Do not repair or modify the product yourself.
Otherwise, it may cause an injury, a fire or an
electrical shock.
In case of thunder, do not touch the power cord.
Otherwise, it may cause an electrical shock.
Connect the product to the correct voltage. If the
product is connected to a voltage other than the
specified voltage, it may lead to a fire or an electrical
shock.
In case of a malfunction (nothing is displayed on
the screen, etc.) or if smoke, abnormal heat, or a
strange sound or odor is generated, turn the power
off and immediately ask a technician or your retailer
for repair.
Do not put objects into the product. Otherwise, it
may cause a fire or an electrical shock.
In case the product is in contact with water or
another liquid, immediately disconnect the power
supply and stop using the product. If you continue
using the product in that state, it may lead to a
malfunction, a fire, or an electrical shock.
This product can only be serviced in the country where it was purchased.
CAUTION
When connecting the power cord to the product’s
AC IN terminal, make sure the connector is fully and
firmly inserted.
Do not damage the power cord. Do not put heavy
objects on it, place it near heaters, pull it with
excessive strength, or apply a strong force on it
while it is bent.
A damaged power cord may cause a fire or an
electrical shock.
Do not install the product in narrow places where
heat tends to build up.
Do not use the product in an environment with low
heat dissipation.
Otherwise, it may cause a malfunction.
Do not use the product in a vehicle or another
means of transportation.
Do not place the product under direct sunlight or
near heaters.
This product is designed to be used indoors. Do
not use it outdoors. Otherwise, it may cause a
malfunction.
Do not use or store the product in the following
places.
• Near heaters
• Places with lots of humidity or dust, or places
subject to oily smoke
• Places where water or oil may splash
• Places with lots of corrosive gases, such as near
hot springs
• Places where the product may freeze
• Do not place the product on its side, face down, or
upside down.
• Places with lots of vibrations
If you will not be using the product for a long time,
disconnect it from the power distributor for safety
purposes.
Disconnect the power supply when performing
maintenance.
Install the product in accordance with local laws and
regulations.
The device must be installed in a housing /
switch cabinet in the end application and must
not be accessible during operation.
To Next Page
Loading...