3
CAUTIONS FOR USE
1. Do not disassemble or repair the electric fan by yourself, it may cause troubles such as a re of electric shock.
Consult your nearest dealer.
2. Incase the power cord is broken, it must be replaced by manufacturer or appointed service providers or
equivalent professionals to avoid any damages.
3. Unplug every time before start to clean the parts or when you do not use the electric fan anymore.
4. Do not immerse the electric fan in water or sprinkling water because this could lead or a short circuit or
equipment broken.
5. Do not insert the nger or any objects through the grille while the blade is rotating.
6. Do not spray any vapor or chemicals to the electric fan while the blade is rotating.
7. Plug in tightly in order to avoid the plug to be overheated. This can cause the plastic to be melted, and
conagrated. When unplugging, hold only the plug part; do not pull the cable as this may cause the cable as
this may cause the cable broken.
8. Do not plug in with the wet hand to prevent any injury from the leaking current.
9. While the electric fan is being used, do not plug in the other electric appliances in the same receptacle as
this might cause heat and conagration respectively.
10. Should not use the electric fan close to curtain, mosquito net or any objects which could be pulled to the
motor, otherwise this may cause accident and damage.
11. Should not use the electric fan at the high temperature place such as placing it close to the stove or the high
humidity place, as the unit might be damaged.
12. Should not place the electric fan on the hot or sloped oor, as the unit might be damaged.
CLEANING AND MAINTENANCE
Blade, Front grille and Rear grille
Disassemble, and wipe with damp cloth use cleaning agent mixed with water then dried up with the cloth.
Body
Wipe with damp cloth using water or mild soapy liquid.
Remark
Do not wet electric parts or motor.
Do not clean with chemical substance, thinner and kerosene etc, as this might damage the surface and/or shape
of unit.
To Next Page
Loading...
