Sharp PJ-ST161 - Component Replacement Procedures - Part 2; Remove Bottom Plate; Remove Power Cord

6
REMOVE OF POWER CORD
1. Remove the base ass’y in accordance with “REMOVE OF BASE ASS’Y”.
2. Remove 2 screws and remove the body cover.
3. Remove 6 screws and separate the front body from back body. (Should be place on jig)
4. Remove 3 screws and cut cord band holding the power cord.
5. Remove the closed terminal and cut the power cord lead wire
from the piano switch ass’y.
6. Now the power cord is free.
REMOVE OF BOTTOM PLATE
1. Remove 2 screws holding base ass’y and detach the unit from the
base ass’y.
2. Remove 6 screws holding the bottom plate.
3. Now the bottom plate is free.
Unit
Jig
Base
Bottom plate
Screw
Fig. 3
Fig. 4
Screw
Screw
Back body
Back body
Front body
Front body
Power cord
Screw
Closed terminal
Cord band
Piano switch ass’y
Lead wire of power cord
Body cover
Unit
Lead wire of motor