Sharp PJ-ST161 - Component Replacement Procedures - Part 5; Remove Reel Spring; Remove Motor Assembly

REMOVE OF MOTOR ASS’Y
1. Remove the grille ass’y in accordance with “REMOVE OF LOCK SPRING COVER”.
2. Remove 3 screws holding the motor bracket.
3. Remove screw holding to the motor cover.
4. Pull the clutch knob from the motor ass’y and remove the motor cover.
5. Remove the screws holding the link rod to the motor ass’y.
6. Remove the screw holding the motor ass’y to the hinge ass’y and remove it.
7. Now the motor ass’y is free.
Fig. 9
Screw
Screw
Screw
Back body
Back body
Reel spring
Adjustable housing ass’y
Motor cover
Motor ass’y
Motor bracket
Screw
Turning axle
Link rod
Knuckle shaft
Screw
Hinge
Clutch knob
Screw
9
REMOVE OF REEL SPRING
1. Remove the lock spring cover in accordance with “REMOVE OF LOCK SPRING COVER”.
2. Remove the screw holding the reel spring.
3. Now the reel spring is free.
Fig. 8