10
REMOVE OF HINGE ASS’Y
1. Remove the motor ass’y in accordance with “REMOVE OF MOTOR ASS’Y”.
2. Remove 2 screws holding the hinge ass’y to the body (For PJ-TA181).
3. Remove 2 screws holding the hinge ass’y to the slide shaft ( For PJ-SL181).
4. Remove the screw holding the link rod to the turning axle.
5. Remove the turning axle from the hinge.
6. Now the hinge ass’y is free.
Screw
Screw
Wave washer
Link rod
Link rod
Turning axle
Steel ball
Steel ball
Turning axle
Hinge
Hinge
Hinge spring
Hinge spring
Screw
Screw
Screw
Screw
Slide shaft
Body
Model : PJ-TA181
Model : PJ-SL181
Hinge support - B
Hinge support
Hinge support
Fig. 6
Wave washer
Turning spring
Ball spring
Steel ball
Nut
Ball spring
Steel ball
Nut
Turning spring
To Next Page
Loading...
