Sharp PN-E702 - Operational Tips and Instructions

ENGLISH
5
E
Supplied Components
Preparing the Remote Control Unit
1. Press the cover gently and slide it in the direction of the arrow.
2. Seetheinstructionsinthecompartmentandputinthesuppliedbatteries(R-6(“AA”size)x2)withtheirplus(+)andminus(-)
sides oriented correctly.
3. Closethecover.
If any component should be missing, please contact your dealer.

LiquidCrystalDisplayMonitor:1

Remote control unit: 1

Cableclamp:2

Power cord: 1

R-6battery(“AA”size):2

CD-ROM(UtilityDiskforWindows):1

Setup Manual (this manual): 1

Verticalsticker(Operationpanel):1

Verticalsticker(Logo):1

Terminal label: 1
UsedwheninstallingtheexpansionboardPN-ZB01(optional).

CoverSharplogo:1
Place this sticker onto the SHARP logo to cover the logo.
* SharpCorporationholdsauthorshiprightstotheUtilityDiskprogram.Donotreproduceitwithoutpermission.
* For environmental protection!
 Donotdisposeofbatteriesinhouseholdwaste.Followthedisposalinstructionsforyourarea.