Sharp PN-HS551

31
E
Your monitor can be connected to a LAN allowing you to
control it from a computer on the LAN.
The connection requires a commercially available LAN cable
(UTP cable, Category 5, straight through).
Network (LAN)
Hub
LAN cable (commercially available, straight)
LAN terminal
Caution
• When you use a network, your communication data is
exposed to the risks of being stolen or illegally accessed.
To avoid these risks, you need to use this monitor in a
secure network environment.
TIPS
• When POWER SAVE MODE is set to ON, the control is
disabled in the standby mode/input signal waiting state.
• To control the monitor via LAN, set RS-232C/LAN SELECT
to LAN. (See page 24.)
• You cannot use RS-232C and LAN control simultaneously.
n
To set on the monitor
Set RS-232C/LAN SELECT of COMMUNICATION SETTING
on the SETUP menu to LAN, and then set the LAN SETUP
options. (See page 24.)
After setting each item, select SET and press the ENTER
button.
VIEW NETWORK SETTINGS
Displays LAN setting information.
DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an
address automatically, change this setting to ON.
To set the address manually, set this to OFF.
IP ADDRESS
If the DHCP CLIENT is set to OFF, specify an IP address.
Press the
or button to select the items, and enter the
values with the numeric input buttons (0 to 9).
You can also change the values with the
or button.
SUBNET MASK
If the DHCP CLIENT is set to OFF, specify the subnet mask.
Press the
or button to select the items, and enter the
values with the numeric input buttons (0 to 9).
You can also change the values with the
or button.
Controlling the Monitor with a computer (LAN)
DEFAULT GATEWAY
If the DHCP CLIENT is set to OFF, specify the default
gateway.
If you are not using a default gateway, specify
“000.000.000.000”.
Press the
or button to select the items, and enter the
values with the numeric input buttons (0 to 9).
You can also change the values with the
or button.
SET
Save the setting.
Command-based control
You can control the monitor using RS-232C commands
(see page 29) via terminal software and other appropriate
applications.
Read the manual for the terminal software for detailed
instructions.
(1) Connect the computer to the monitor.
1. Specify the IP address and data port number (10008)
and connect the computer to the monitor.
When connection has been established successfully,
[Login:] is returned as response.
2. Send the user name.
• Send [user name] + [
].
• If the user name is not set, send [
].
• When the transmission is successful, [
Password:]
is returned as response.
3. Send the password.
• Send [password] + [
].
•
If the password is not set, send [ ]. [ New password:]
is returned as response. Please set a password.
Send [password] + [
]. [ Retype new password:]
is returned as response. Send [password] + [
]
again.
• When the transmission is successful, [OK
] is
returned as response.
(2) Send commands to control the monitor.
• The commands used are the same as those for RS-
232C. Refer to the communication procedure (see
page 28) for operation.
• Usable commands are provided in the RS-232C
command table (see page 29).
(3) Disconnect the connection with the monitor and
quit the function.
1. Send [BYE ].
When the transmission is successful, [goodbye] is
returned and the connection is disconnected.