Sharp PN-HS551

33
E
Specications
n
Product Specications
Model PN-HS551 PN-HY551 PN-HS501 PN-HY501 PN-HS431 PN-HY431
LCD component 55" Class [54-5/8 inch
(138.783 cm) diagonal]
TFT LCD
50" Class [49-1/2 inch
(125.730 cm) diagonal]
TFT LCD
43" Class [42-1/2 inch
(107.986 cm) diagonal]
TFT LCD
Max. resolution (pixels) 3840 x 2160
Max. colors Approx. 1.07 billion colors
Pixel pitch 0.315 mm (H) ×
0.315 mm (V)
0.2854 mm (H) ×
0.2854 mm (V)
0.2451 mm (H) ×
0.2451 mm (V)
Brightness (typical) *
1
700 cd/m
2
500 cd/m
2
700 cd/m
2
500 cd/m
2
700 cd/m
2
500 cd/m
2
Contrast ratio (typical) 5000: 1 4000: 1 1200: 1
Viewing angle 178° right/left/up/down (contrast ratio ≥ 10)
Screen active inch (mm)
area
47-5/8 (W) x 26-13/16 (H)
(1209.6 x 680.4)
43-1/8 (W) x 24-1/4 (H)
(1095.84 x 616.41)
37-1/16 (W) x 20-13/16 (H)
(941.184 x 529.416)
Computer input signal Analog RGB (0.7 Vp-p) [75 Ω]
Sync signal Horizontal/vertical separate (TTL: positive/negative)
Plug and play VESA DDC2B
Input
terminals
Video Mini D-sub 15 pin, 3 rows x 1
HDMI x 3
Serial (RS-232C) D-sub 9 pin x 1
Audio 3.5 mm mini stereo jack x 1
Output
terminals
Audio RCA pin (L/R) x 1
IR 3.5 mm mini stereo jack x 1 *
2
USB port USB (USB 2.0 compliant) x 1
LAN terminal 10 BASE-T/100 BASE-TX
Speaker output 10 W + 10 W
Power requirement
AC 100 - 240 V,
2.1 A,
50/60 Hz
AC 100 - 240 V,
1.8 A,
50/60 Hz
AC 100 - 240 V,
1.7 A,
50/60 Hz
AC 100 - 240 V,
1.3 A,
50/60 Hz
AC 100 - 240 V,
1.6 A,
50/60 Hz
AC 100 - 240 V,
1.2 A,
50/60 Hz
Operating temperature *
3
32°F to 104°F (0°C to 40°C)
Operating humidity 20% to 80% (no condensation)
Power consumption
(input signal waiting state /
networked standby mode *
4
/
standby mode *
4
/ o󰀨 mode)
190W
(1.0W / 1.0W /
0.5W / 0.0 W)
150W
(1.0W / 1.0W / 0.5W / 0.0 W)
110W
(1.0W / 1.0W /
0.5W / 0.0 W)
140W
(1.0W / 1.0W /
0.5W / 0.0 W)
100W
(1.0W / 1.0W /
0.5W / 0.0 W)
Dimensions inch (mm)
(excluding protrusions)
Approx. 48-7/8 (W) x
2-1/2 (D) x 28-1/16 (H)
(1241.8 x 63.5 x 712.6)
Approx. 44-7/16 (W) x
2-1/2 (D) x 25-9/16 (H)
(1128.4 x 63.5 x 649)
Approx. 38-5/16 (W) x
2-1/2 (D) x 22-1/8 (H)
(973 x 63.5 x 561.2)
Weight lbs. (kg) Approx. 39.7 (18.0) Approx. 33.1 (15.0) Approx. 25.4 (11.5)
*1 Brightness will depend on input mode and other picture settings. Brightness level will decrease over time. Due to the nature of the
equipment, it is not possible to precisely maintain a constant level of brightness.
*2 The conversion cable to D-sub 9 pins is an option.
*3 When using the monitor laying at on a surface (when the monitor is tilted more than 20 degrees upward or downward from the
perpendicular in relation to a level surface), use the monitor at a temperature between 32°F (0°C) to 86°F (30°C).
Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such
cases, please check the temperature condition specied by the optional equipments.
*4 No optional part is attached.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specication changes for
product improvement without prior notice. The performance specication gures indicated are nominal values of production
units. There may be some deviations from these values in individual units.