Sharp PN-L702B

ENGLISH
5
E
Supplied Components
Preparing the Remote Control Unit and the Touch Pen
Installing the batteries
1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
suppliedbatteries(R-6(“AA”size)x2)withtheirplus(+)
andminus(-)sidesorientedcorrectly.
3. Closethecover.
Inserting the battery
1. Rotate the battery cap and remove it, and then pull out the
cover.
Battery cap
2. Insertthesuppliedbattery(LR-03(“AAA”size))inthe
orientation shown, and attach the cover and battery cap.
If any component should be missing, please contact your dealer.

LiquidCrystalDisplayMonitor:1

Remote control unit: 1

Cableclamp:2

Power cord: 1

R-6battery(“AA”size):2

CD-ROM(UtilityDiskforWindows):1

Setup Manual (this manual): 1
* SharpCorporationholdsauthorshiprightstotheUtilityDiskprogram.Donotreproduceitwithoutpermission.
* For environmental protection!
 Donotdisposeofbatteriesinhouseholdwaste.Followthedisposalinstructionsforyourarea.

Touch pen: 1

Pen tip (for touch pen): 2

Touch pen battery
(LR-03(“AAA”size)):1

USBcable:1

Eraser: 1

Tray: 1

Traymountingtting(cover/bracket):x2

Traymountingscrews:M5x4/M4x2

Terminal label: 1
Used when installing the interface
expansionboardPN-ZB01(optional).

CoverSharplogo:1
Place this sticker onto the SHARP logo to
cover the logo.