Sharp PN-V602 - Specifications: Dimensional Drawings and Power Management; Dimensional Drawings and Mounting; Power Management Standards (DPMS, DMPM)

56
E
Specications
n
Dimensional Drawings
Note that the values shown are approximate values.
Unit: inch [mm]
52-5/8 [1335.9]
Opening width (52-5/16 [1329.4])
Opening height (29-7/16 [747.7])
29-11/16 [754.2]
7-7/8 [200]
5-7/8
[149.3]
52-5/8 [1335.9]
3-5/8
[92.3]
7-7/8
[200]
7-7/8
[200]
VESA holes *
3-15/16
[100]
3-15/16
[100]
 Whenmountingthemonitor,besuretouseawall-mountbracketthatcomplieswiththeVESA-compatiblemountingmethod.
SHARP recommends using M6 screws and tighten the screws.
Notethatscrewholedepthofthemonitoris3/8inch(10mm).Loosemountingmaycausetheproducttofall,resultingin
seriouspersonalinjuriesaswellasdamagetotheproduct.Thescrewandholeshouldcometogetherwithover5/16inch
(8mm)lengthofthread.UseabracketwhichhasbeenapprovedforUL1678standard,andwhichcanendureatleast4times
or more the weight of the monitor.
n
Power management
ThismonitorconformstoVESADPMSandDVIDMPM.Bothyourvideocardandcomputermustsupportthesamestandardin
order for the monitor’s power management function to work.
DPMS:DisplayPowerManagementSignaling
DPMS Screen
Power
consumption*
1
Hsync Vsync
ONSTATE Display 510W Yes Yes
STANDBY
No
display
1.0W*
2
No Yes
SUSPEND Yes No
OFFSTATE No No
*1 WhenPN-ZR01(optional),orPN-ZB02(optional)isnot
connected.
*2 WhenAUTOINPUTCHANGEissettoOFF.
DMPM:DigitalMonitorPowerManagement
DMPM Screen
Power
consumption*
1
Monitor ON Display 510W
ActiveOFF No display 1.0W*
2
n
POWER LIMITED (See page 24.)
MODE Power consumption
MODE2 195W
MODE1 310W
OFF 510W
Settoensuremaximumpowerconsumption.(Seepage55.)
n
DDC (plug and play)
ThemonitorsupportstheVESADDC(DisplayDataChannel)standard.
DDCisasignalstandardforplugandplaybetweenmonitorsandcomputers.Informationaboutresolutionandotherparameters
isexchangedbetweenthetwo.ThisfunctioncanbeusedifthecomputersupportsDDCandithasbeenconguredtodetect
plug-and-playmonitors.
ThereareseveraltypesofDDC,dependingonthecommunicationmethodused.ThismonitorsupportsDDC2B.