12
E
Connecting Peripheral Equipment
5. DVI-D input terminal
• Use a commercially available signal cable (DVI-D 24 pin).
6. D-sub input terminal
• Set D-SUB of INPUT SELECT on the SETUP menu
according to the device to be connected.
7. Audio input terminal
• Use an audio cable without resistance.
• Set the audio input terminal to be used in each input
mode in AUDIO SELECT on the SETUP menu.
8. Audio output terminal
• The output sound varies depending on the input mode.
• The volume of the output sound can be xed by setting
AUDIO OUTPUT on the SETUP menu.
9. RS-232C input terminal
10. RS-232C output terminal
• You can control the monitor from a computer by
connecting a commercially available RS-232 straight
cable between these terminals and the computer.
11. LAN terminal
• You can control the monitor from a computer on a network
by connecting a commercially available LAN cable
between this terminal and a network.
12. Control kit terminal
• Connects the remote control sensor box of the PN-ZR02
control kit (optional). (See page 14.)
To Next Page
