EasyManua.ls Logo

Sharp PN-V701 - Page 46

Sharp PN-V701
70 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
E
Controlling the Monitor with a computer (RS-232C)
Function
Command Direction
Parameter Reply Control/Response contents *
DisplayPort SETTING HIGH-FREQUENCY
GAIN
DPHG WR 0-31 0-31
-
LOW-FREQUENCY
GAIN
DPLG WR 0-31 0-31
FILTER SETTING DPFL WR 0-15 0-15
OFFSET DPOF WR 0-15 0-15
RESET DPRS W 1
AUDIO SELECT HDMI1
ASHP WR 0-1 0-1
0: HDMI, 1: AUDIO
HDMI2
AH2P WR 0-1 0-1
0: HDMI, 1: AUDIO
DisplayPort
ASDI WR 1, 3 1, 3
1: AUDIO, 3: DisplayPort
OPTION
ASOP WR 0-1 0-1
0: OPTION, 1: AUDIO
(valid when you have used the expansion slot to expand the functions)
AUDIO OUTPUT
AOUT WR 0-1 0-1
0: VARIABLE, 1: FIXED
START INPUT MODE SUIM WR
1-4, 6-7, 10 1-4, 6-7, 10
1: LAST INPUT MODE, 2: DisplayPort, 3: HDMI1, 4: HDMI2, 6: DVI-D, 7: D-SUB,
10: OPTION
(valid when you have used the expansion slot to expand the functions)
COMMUNICATION
SETTING
RS-232C/LAN
SELECT
CTLS WR 0-1 0-1 0: RS-232C, 1: LAN
BAUD RATE
BAUD WR 0-2 0-2 0: 9600bps, 1: 19200bps, 2: 38400bps
Crestron Connected
CRCN WR 0-1 0-1 0: OFF, 1: ON
ID SETTING ID No.SET IDST W 0-255 Sets the monitor’s ID number. (“0” means “no ID number”.)
R 0-255 Returns the monitor’s ID number.
ID NO. SETTING
(ONCE)
IDSL W 1-255 Set a monitor’s ID number to send a command.
This ID number is only effective for the command immediately after this command.
0 Clears the ID number if one has been designated.
ID NO. SETTING
(SUBSEQUENT)
IDLK W 1-255 Set a monitor’s ID number to send a command.
This ID number is effective for the next and all subsequent commands after this
command.
0 Clears the ID number if one has been designated.
ID CHECK IDCK W 0 ID : xxx
IDLK : yyy
Displays monitor’s own ID number and the selected ID number on the screen.
ID DISPLAY IDDP W 0-2 0: OFF, 1: ON, 2: ON (turns OFF after 4 sec.)
(The IP address and MAC address are both displayed.)
-
REMOTE No. RCNO WR 0-9 0-9 Sets the number of the remote control unit.
COPY SETTING
VALUE
COPY TO ID No. CPMD WR 0 0 Copy to all monitors.
1-255 1-255 Copy to the monitor with the set ID number.
COPY SETTING
VALUE TARGET
CPTG WR 0 0 Copies the PICTURE menu settings.
1 1 Copies all the settings.

Other manuals for Sharp PN-V701

Related product manuals