Sharp R-15AT - MEMORY CHECK; Checking Programmed Memory Data

9
MEMORY CHECK
NO. CHECK
NO. CHECK
Step
Procedure
Press the CHECK key.
1
You can check the information programmed into the memory.
Checking time and power level
Example: If you want to know the information programmed into the memory 1, memory 1 has been programmed
for 4 minutes on 60% for the 1st sequence and 2 minutes on 30% for the 2nd sequence.
Display
Key Order
NO. will flash on and off.
2
After about 1 sec.
Press the NUMBER key
.
CHECK
CHECK
CHECK
CHECK
Note: 1. To cancel MEMORY CHECK, press the CHECK key .
2. When
is displayed after pressing the NUMBER key, the memory is not set.
3. To check the time constant for double quantity, press the DOUBLE QUANTITY key
and the
desired NUMBER key in step 2.
REPEAT
P = Power
SEEG R15AT O/M(E),P04-13 13.7.9, 8:56 AM9