Sharp R-202 User Manual

4. Ensure there is a minimum free space above the
oven of 15 cm.
5. Make sure the TIMER knob is set in the “
●” (off)
position.
6. Securely connect the plug of the oven to a
standard earthed (grounded) household electrical
outlet.
1. Remove all packing materials from the inside of
the oven cavity. Discard the loose polythene sheet
from between the door and cavity. Remove the
feature sticker, if attached, from the outside of the
oven door.
Do not remove the protective film attached to the
inside of the door
2. Check the oven carefully for any signs of damage.
3. Place the oven on a flat, level surface strong
enough to support the oven’s weight plus the
heaviest item likely to be cooked.
✓
✗
INSTALLATION
6
IMPORTANT SAFETY INSTRUCTIONS
15cm
NOTE:
If you are unsure how to connect your oven, please
consult an authorised, qualified electrician.
Neither the manufacturer nor the dealer can accept
any liability for damage to the oven or personal
injury resulting from failure to observe the correct
electrical connection procedure.
Water vapour or drops may occasionally form on
the oven walls or around the door seals and
sealing surfaces. This is a normal occurrence and
is not an indication of microwave leakage or a
malfunction.

Sharp R-202 Specifications

Power

AC line voltage	230V, 50Hz, single phase
AC power required	1.24KW
output power	800W(IEC 705)
microwave frequency	2450MHz
oven lamp	25W/240-250V

Capacity

oven capacity	20 litres

Weight and Dimensions

outside dimensions	449mm(W) x 282mm(H) x 385mm(D)
cavity dimensions	287mm(W) x 220mm(H) x 311mm(D)
turntable diameter	ø272mm
weight	Approx. 13.3kg