Sharp R-23AT Original Instruction

GB-10
ENGLISH
X 2
Setting magnifi cation factor
It is possible to change the magnifi cation factor for double quantity in the memory.
Example : Suppose you want to set the magnifi cation factor to 1.67 for double quantity in memory 1.
Choose checking mode.
Action
Step
Press key Display
4
5
6
3
Choose double quantity.
Action
Step
Press key Display
within 2 sec.
Choose set mode.
1
2
Choose memory number.
Touch MANUAL/REPEAT key.
Enter magnifi cation factor.
Complete memorizing.
NOTE:
When
is displayed at step 2 or step 3, the memory is not set.
1
2
Choose memory number.
Cancel checking mode.
3
4
Choose memory number.
NOTE:
1. In case you want to change the magnifi cation factor it must be set for each key separately.
2. The magnifi cation factor can be set from 0.00 to 9.99.
3. At Step 1, any audible signals will not sound when the SET key is touched fi rst and then an audible signal
will sound when the SET key is touched second.
MEMORY CHECK
You can check the information programmed into the memory.
Checking time and power level
Example : Suppose you want to know the information programmed into the memory 1, programmed for 4 minutes
at 60% at the 1st sequence and 2 minutes at 30 % at the 2nd sequence, and after that the memory
13, programmed for 3 minutes at 70 %.
NUMBER
DOUBLE
X 2
X 2
2 X
NUMBER
DOUBLE
NUMBER
DOUBLE
NUMBER
1
1 6 7
NUMBER
DOUBLE
3
CHECK
NUMBER
CHECK
POWER
%
NUMBER
1
Repeat
CHECK
POWER
%
NUMBER
2
CHECK
POWER
%
NUMBER
1
1
R23AT_OM_NORDIC_5_EN_SE_NO_FI_DK10 10R23AT_OM_NORDIC_5_EN_SE_NO_FI_DK10 10 2013-12-02 11:15:112013-12-02 11:15:11

Sharp R-23AT Specifications