Sharp R-23AT Original Instruction

GB-17
Please check the following before calling for service.
1. Power Supply
Check the power plug is properly connected to a suitable wall outlet.
Check the line fuse/circuit breaker is functioning properly.
2. When the door is opened:
A. Does the oven lamp light? YES _____ NO ______
B. Does the cooling fan work? YES _____ NO ______
(Put your hand over the rear ventilation opening.)
3. Place one cup of 150 ml water in the oven and close the door securely.
Touch these keys.
A. Does the cook indicator go on? YES _____ NO ______
B. At the end of this time, is the water warm? YES _____ NO ______
If "NO" is the answer to any of the above questions, call your dealer or an authorized SHARP Service Agent and
report the results of your check.
1 0 0
Door
To remove all trace of dirt, regularly clean both sides
of the door, the door seals and adjacent parts with a
soft, damp cloth. Do not use abrasive cleaner.
Air intake fi lter
SERVICE CALL CHECK
Keep clean the air intake fi lter. To clean the air intake
fi lter you have to pull the two clips on the fi lter and to
remove the air intake fi lter. Wash the air intake fi lter in
mild soapy water and dry with a soft cloth. After clean-
ing re-install the air intake fi lter to the oven. Clean the
air intake fi lter once every two weeks.
CAUTION:
DO NOT OPERATE THE OVEN WITHOUT THE
AIR INTAKE FILTER IN PLACE.
Hole
Oven
Hole
Clip
Air intake fi lterClip
R23AT_OM_NORDIC_5_EN_SE_NO_FI_DK17 17R23AT_OM_NORDIC_5_EN_SE_NO_FI_DK17 17 2013-12-02 11:15:122013-12-02 11:15:12

Sharp R-23AT Specifications