MEMORY READJUSTMENT PROCEDURE
1. To set the ON/OFF timing of relay RY2.
When the IC3 changed in the control unit. the ON/OFF timing of relay RY2 must be set again to avoid the inrush noise.
PAD ORDER
I
DISPLAY
/ PHONE]
(Door close)
(Plug in)
(BLANK)
I I
I
I
A.START/CLOCK
I
*I O I
I
GRILL
I
POWER LEVEL
INST.COOK
TEST 0
START
I
8
I
I
(T.0.D)
I
I
I
1.7.0.0
I
1700/ 0x4
1
POWER LEVEL
I
17001 0 ’
!
/
CT\
&/
I
HIGH j
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
WARNING: Avoid possible exposure to microwave energy. Please follow the instructions below .brbefore op-
I
erating the oven.
1. CARRY OUT 3D CHECKS.
3. The door gasket or seal is damaged.
2. Make sure that, when unlatching the door slowly, an ac-
4. The door is bent or warped.
companying “click” indicating the actuation of the moni-
‘I
tor switch and latch switches is heard.
5. There are defective parts in the door interlock system.
3. Visually check the door and cavity face plate for dam-
6. There are defective parts in the microwave generating
age (dents, cracks, signs of arcing etc.).
and transmission assembly.
7. There is visible damage to the oven.
Carry out any remedial work that is necessary before oper-
Do not operate the oven:
ating the oven.
1. Without the RF gasket (Magnetron).
Do not operate the oven if any of the following conditions
exist
1. Door does not close firmly.
2. Door hinge, support or latch hook is damaged.
2. If the wave guide or oven cavity are not intact.
3. If the door is not closed.
4. If the outer case (cabinet) is not fitted.
Please refer to ‘OVEN PARTS, CABINET PARTS, DOOR PARTS’, when carrying out any of the following removal proce-
dures:
31
To Next Page
Loading...
Need help?
General
