Need help?Do you have a question about the Sharp SPC900 and is the answer not in the manual?
Details the battery requirements for the main unit and remote sensor.
Provides the physical size (width, height, depth) for the main unit and remote sensor.
Details how to set up and operate the weather station for signal reception.
Steps for inserting batteries into the transmitter and confirming channel setting.
Explains the necessity of synchronizing transmitter and receiver channels.
Explains automatic synchronization with USA (WWVB) time signal.
Describes the clock's behavior when receiving signals for the first time.
The pre-alarm sounds 30 minutes early if outdoor temperature is below a threshold.
Explains how to set the time zone using the TIME and UP keys.
Allows manual setting of year, month, date, hour, minute, and second.
Set alarm time and press ALM ON/OFF to activate alarm and pre-alarm icons.
Press ALM ON/OFF again to turn off both alarms until icons disappear.
To Next Page
General
