To Next PageTo Next Page
Need help?Do you have a question about the Sharp SPC971 and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Atomic Time | Yes |
| Alarm | Yes |
| Snooze | Yes |
| Backlight | Yes |
| Weight | 0.6 pounds |
| Type | Digital |
| Power Source | Battery Operated |
Press and hold M.SET to enter manual setting mode. Pressing again advances the minute hand.
Press and hold REC to start atomic time signal reception within 10 minutes.
Select DST mode before inserting battery for automatic daylight saving time adjustment.
Slide the switch to M, C, or E for Mountain, Central, or Eastern Time zones.
Use one AA size battery for the clock.
Check indicators for low battery in transmitter or main clock unit.
If WWVB signal is not received immediately, wait overnight for automatic setting.
Handle batteries carefully: clean contacts, observe polarity, do not mix types, remove if unused.
Follow all operating instructions, avoid water, clean with dry cloth, ensure ventilation.
Do not defeat plug safety features, use specified attachments, unplug during storms or long periods.
Refer servicing to qualified personnel. Do not attempt repairs unless qualified.
Ensure good ventilation, do not block openings, avoid heat sources, and confined spaces.
Do not expose to dripping, liquids, or excessive heat. Dispose of batteries safely.
