28
AUTOMATIC TWO-SIDED COPYING
Two originals can be automatically copied onto both sides of a single sheet of paper. When the RSPF is used,
two-sided copies of two-sided originals can easily be made.
USING THE DOCUMENT GLASS
1
Place the original on the document
glass. (p.23)
2
Touch the [2-SIDED COPY] key.
3
Touch the [One-sided to two-sided
copy] key.
4
Touch the [OK] key.
Original → Paper
Document glass
One-sided original
→ Two sid es ( )
RSPF
One-sided original
→ Two sides
()
Two-sided original
→ Two sides
()
Two-sided original
→ One side
()
• Paper sizes that can be used are 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 13", 8-1/2" x 14" and 11" x 17" (A5, B5,
B5R, A4, A4R, B4, and A3).
• When making two-sided copies on letterhead paper, place the side with the letterhead face down if using a
tray, or face up if using the bypass tray (This is the opposite of normal.).
•
Automatic two-sided copying is not possible on thick paper, thin paper, labels, transparency film, envelopes, and
other special types of paper.
• Automatic two-sided copying can be disabled in the administrator settings. (See "6. SYSTEM SETTINGS
(ADMINISTRATOR)".)
•
When dual page copy (p.44) is selected, two-sided original to two sides or two-sided original to one side cannot be used.
Note
Portrait-oriented original
(11" x 17" or 8-1/2" x 14" size)
Before [BINDING CHANGE] After [BINDING CHANGE]
Touch the [BINDING CHANGE] key when making the tablet
binding, or when making automatic two-sided copies of a
one-sided 11" x 17" or 8-1/2" x 14" size portrait original,
touch the [BINDING CHANGE] key.
MX-M310.book 28 ページ ２００９年７月６日 月曜日 午後６時５７分
To Next Page
Loading...
