18
TU-GA1U-S
TU-GAD
[Adjustment procedure]
* Before entering the process adjustment mode, press "TV Reset" switch on the AVC system. Or enter the TV
menu video adjustment mode, change the AVC position to "Dynamic" and execute "Reset" in the bottom of the
menu.
1) N358 signal adjustment [N358ALLADJ]
Adjusting point Adjusting conditions Adjusting procedure
1 Input signal setting
2 RF input/Video input
MAIN/SUB screen
• Contrast
• CB / CR GAIN
1) Using the input signal generator, feed the split field
color bar signal -- US10ch (193.25 MHz), RF
modulation -- to the tuner -A/-B.
• Color saturation 75%
• RF modulation 87.5%
• Bottom white window Vertical: 1/4V
2) Using the input signal generator, feed the full field
color bar signal to the Video 1 input terminal.
• Color saturation 75%
• Input signal should be 1.00 Vp-p (Sync - 100%
white) with 75Ω termination of the signal
generator video output.
1) Input signal setting
2) Video 1 input terminal
connection signal
1) Enter the process adjustment mode.
2) Bring the cursor on to [N358 ALL ADJ] on Page 3.
3) Press [ENTER] key of the remote controller. The
adjustment is done automatically.
Ë For each input, operate in the following order.
1) Video input: Bring the cursor on to [N358 MAIN
ADJ] and press [ENTER].
2) Video input: Bring the cursor on to [N358 SUB ADJ]
on Page 4 and press [ENTER].
3) RF input: Bring the cursor on to [TUNER DAC ADJ]
and press [ENTER].
Feed the signal adjusted as
above.
White 75%
White
100%
Yellow
Green
Red
Magenta
Cyan
Black
White
Yellow
Green
Red
Blue
Magenta
Cyan
Black
To Next Page
Loading...
