Sharp TU-GA1U-S - Part Names (Continued); AVC System Front and Rear Views

19
TU-GA1U-S
TU-GAD
Adjusting point Adjusting conditions Adjusting procedure
1 Input signal setting
2 15K component signal
input
• Contrast
• CB / CR GAIN
• Y / CB / CR OFFSET
1) Using the input signal generator, feed the full field
color bar signal to the Video 1 input terminal.
• Color saturation 100%
• Input signal should be 1.00 Vp-p (Sync - 100%
white) with 75Ω termination of the signal
generator video output.
1) Enter the process adjustment mode.
2) Bring the cursor on to [COMP15K ALL ADJ] on
Page 5.
3) Press [ENTER] key of the remote controller. The
adjustment is done automatically.
Feed the signal adjusted as
above.
White
Yellow
Green
Red
Blue
Magenta
Cyan
Black
2) 15K component signal adjustment [COMP15KALLADJ]
Adjusting point Adjusting conditions Adjusting procedure
1 Input signal setting
2 HDTV component
signal input
• CONTRAST
• CB GAIN
• CR GAIN
• Y OFFSET
• PB OFFSET
• PR OFFSET
1) Using the input signal generator, feed the full field
color bar signal to the Video 1 component input
terminal.
• Color saturation 100%
• Input signal should be 1.00 Vp-p (Sync - 100%
white) with 75Ω termination of the signal
generator video output.
Video 1 component input
terminal connection signal
1) Enter the process adjustment mode.
2) Bring the cursor on to [HDTV ADJ] on Page 7.
3) Press [ENTER] key of the remote controller. The
adjustment is done automatically.
Feed the signal adjusted as
above.
White
Yellow
Green
Red
Blue
Magenta
Cyan
Black
3) HDTV component signal adjustment [HDTV ADJ]
Video 1 component input
terminal connection signal