35
Even when a machine has been programmed to disallow entries after individual general resetting or has not
been programmed to allow automatic clearing operation of the individual resetting memory at the time of
consolidation general resetting, you can unlock the machine through reset clear operation in order to restart
entries.
1. Enter the X1/Z1 or X2/Z2 mode from the mode selection window.
2. Select “RESET CLEAR” from the displayed menu.
The MACHINE No. window will appear.
3. If you wish to unlock all the locked machines in the system, select “1 ALL.” If you wish to unlock specific
machines, select “2 MACHINE SELECT.” In this case, the MACHINE SELECT window will appear.
Touch a desired machine number(s) line and select “YES,” and then touch the [CONTINUE] key.
8. Reset clear operation (X1/Z1 and X2/Z2 modes) – master
To Next Page
Loading...
